
description
Product Description
Lamp
- PL Remodel Housing for remodel application where back side of ceiling is not accessible
- Installs through an opening in the ceiling from below
- Secures in place with factory supplied remodel clips
- Design for use in non-insulated areas
- If installed where insulation is present, the insulation must be pulled back 3” from all sides of the PL housing
Lamp
- One 13W Quad or Triple (4-pin) CFL lamp.
- Lamp not included
- Supplied with spring to accommodate certain trim installations, or can be attached to top of housing for certain trims.
- 120V thru 277V HPF Rapid Start Electronic with end-of-life lamp protection
- UL listed/CSA certified.
- See PDF spec for trim selections
- Trim not included
- UL listed for damp locations
- Union made
- UL and C-UL Listed
- Trims 239, 240, 241, 243, 271, 2330, 6101 and 9900 are wet location approved for covered ceiling applications.
- All reports are based on published industry procedures; field performance may differ from laboratory performance.
Share your knowledge of this product. Be the first to write a review »
Browse for more products in the same category as this item: